MATERIAL SAFETY DATA SHEET

SECTION I - Identity – EPOXY SEAL

ES INDUSTRIAL CORP.  P.O. BOX 843 RED BANK, NJ 07701

Date Prepared  05-11-2000   For Emergency   800-877-2436   For Information  800-877-2436

SECTION II – HAZARDOUS INGREDIENTS/IDENTITY INFORMATION

Hazardous Component(s)              CAS #                      OSHA  PEL             ACGIH  TLV                  Other Limits              %(opt)  

DIETHYLENETRIAMINE                111-40-0                                                           PPM-100

TRIETHYLENETETRAMINE          112-24-3                       NO                               PPM-100                                                          20-28 

TETRAETHYLENEPENTAMINE    112-57-2                                                           PPM-100                                     

2-ETHOXYETHANOL                      110-80-5                       YES                              PPM-5                                                               5-7

ACETIC ACID                                     64-19-7                        NO                               PPM-10                                                         1.6-2.3 

SECTION III – PHYSICAL & CHEMICAL CHARACTERISTICS

Boiling Point:   N/A             Specific Gravity (H2O = 1): N/A    Vapor Pressure (mm Hg):  0.2 2MM/HG, 0.01 MM/HG, 0.01 MM/HG, 3.8 MM/HG, 11.4 MM/HG            Melting Point: N/A                Vapor Density (Air =1):  HEAVIER THAN AIR           Evaporation Rate(Water = 1): 1

Solubility % Water:  N/A       Appearance & Odor: 

SECTION IV – FIRE AND EXPLOSION HAZARD DATA

Flash Point (Method Used):  200 F    Flammable Limits in Air/Volume: Lower : NONE    Upper: NONE

Extinguisher Media:  REGULAR FOAM, CARBON DIOXIDE OR DRY CHEMICAL     Special Fire Fighting Procedures:  SELF-CONTAINES BREATHING APPARATUS WITH A FULL FACE  PIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE PRESSURE MODE.  

Unusual Fire/Explosion Hazards: NONE

SECTION V – REACTIVITY DATA

Stability-Cond to Avoid: STABLE     Hazardous Polymerization-Cond. To Avoid: WILL NOT OCCUR

Hazardous Decomposition Products:  MAY FORM TOXIC MATERIALS- CARBON DIOXIDE AND CARBON MONOXIDE

Incompatibility (Materials to Avoid):  AVOID CONTACT WITH STRONG BASES, AMINE, MERCAPTANS AND EXCESSIVE HEAT

SECTION VI – HEALTH HAZARDS DATA

Routes of Entry: Inhalation :  X  Skin:  X   Ingestion:  X    Health Hazards(Acute & Chronic) NONE KNOWN

Signs & Symptoms of Overexposure:  EYES:  CAN CAUSE IRRITTION, REDNESS, TEARING, BLURRED VISION.  SKIN:  CAN CAUSE MODERATE IRRITATION, DEFATTING DERMATITIS.  INHALATION:  CAN CAUSE NAUSEA AND HEADACHE, IRRITATION TO THE RESPRIRATORY TRACT, LIVER AND KIDNEY DAMAGE, BONE MARROW, BLOOD CELL AND CENTRAL NERVOUS SYSTEM DAMAGE.  INGESTION:  CAN CAUSE GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING AND DIARRHEA

Chemical Listed as Carcinogen: NONE     NTP: NO     IARC Monographs: NO

Condition Generally Aggravated by Exposure: NONE KNOWN

Emergency and First Aid Procedures

Inhalation    REMOVE INDIVIDUAL TO FRESH AIR.  IF BREATHING IS DIFFICULT, ADMINISTER OXYGEN.  IF BREATHING HAS STOPPED, GIVE ARTIFICIAL RESPIRATION.  KEEP PERSON WARM, QUIET AND GET MEDICAL ATTENTION

Eyes         FLUSH WITH LARGE AMOUNTS OF WATER, LIFTING UPPER AND LOWER LIDS OCCASIONALLY, GET MEDICAL ATTENTION 

Skin             THOROUGHLY WASH EXPOSED AREA WITH SOAP AND WATER.  REMOVE CONTAMINATED CLOTHING.  LAUNDER CONTAMINATED CLOTHING BEFORE RE-USE

Ingestion      DO NOT INDUCE VOMITTING, KEEP PERSON WARM, QUIET, AND GET MEDICAL ATTENTION

SECTION VII – PRECAUTIONS FOR SAFE HANDLING AND USE

Handling & Storage Precautions:  NONE

Other Precautions:  CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN EMPTIED.  SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUE (VAPOR, LIQUID, AND/OR SOLID), ALL HAZARD PRECAUTIONS GIVEN IN THIS DATA SHEET MUST BE OBSERVED

If Material is Released/Spilled:  FOR SMALL SPILLS ABSORB LIQUID ON PAPER, VERMICULITE, FLOOR ABSORBENT, OR OTHER ABSORBENT MATERIAL AND TRANSFER TO VENTILATED CLOSURE.  FOR LARGE SPILLS ELIMINATE ALL IGNITION SOURCES (FLARES, FLAMES INCLUDING PILOT LIGHTS, ELECTRICAL SPARKS, ETC.).  PERSONS NOT WEARING PROTECTIVE EQUIPMENT SHOULD BE EXCLUDED FROM AREA OF SPILL.  STOP SPILL AT SOURCE, DIKE AREA OF SPILL TO PREVENT SPREADING, PUMP LIQUID TO SALVAGE TANK.  REMAINING LIQUID MAY BE TAKEN UP ON SAND, CLAY, EARTH, FLOOR ABSORBENT, OR OTHER ABSORBENT MATERIAL AND SHOVELED INTO CONTAINERS.

Waste Disposal:  DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS   

SECTION VIII– CONTROL MEASURES

Respiratory Protection: NOT REQUIRED    Ventilation Local/Mechanical:  ADEQUATE PRODUCING NORMAL AIR DILUTION

Special: NONE     Other:         Protective Gloves:  WEAR RESISTANT GLOVES SUCH AS BUNA-N    Eye Protection:  CHEMICAL SPLASH GOGGLES IN COMPLIANCE WITH OSHA REGULATIONS ARE ADVISED, HOWEVER, OSHA REGULATIONS ALSO PERMIT OTHER SAFETY GLASSES

Protective Clothing Equipment:  WEAR IMPERVIOUS CLOTHING AND BOOTS        Work/Hygienic Practices: WASH HANDS AFTER USING